Invacare EC-Track Robin Manuel De Maintenance page 10

Invacare®EC-Track™
Wall support leg, console and wall support foot
Type
Wall support leg
Wall support console
Wall support foot
End Stop
Type
End stop
end stop for traverse rail
In some countries/local areas there is a demand for double securing of the end stops. Such extra securing can be achieved by installing
one of the following:
•
M5x16 mm thread forming screw (e.g. Bufab/Swebolt MRX or equal), 10 mm from each end of the rail, 25 mm from the rail
underside (the screw can be installed in a pre-drilled hole Ø4,3 mm).
10
Description
To be used if the wall does not
have sufficient carrying capacity
when mounting the rail to the
wall. May be used for the mono
rail systems as well as the traverse
systems.
Leg length: 2.6 m / 3 m
The console is also used together
with the end hung wall bracket
when mounting straight or
diagonal.
Low foot for rooms without
skirting board
High foot for rooms with skirting
board pan along the floor
Description
The end stop is mounted at all
rail outlets, which ensures that
the trolleys do not leave the rail
system.
When the end stop is mounted,
the rubber plug is to face towards
the trolley.
When the traverse system is
between-hung, the traverse rails
end stop is to be mounted in the
traverse trolley.
When the rails are mounted to a
wall, the end stop is to be placed
so far into the rail that the hoist
does not hit the wall
Info
Installation: See chapter 3.7 Wall
support legs, page 19
Info
1586749-B