Publicité
Les langues disponibles
Les langues disponibles
WARNI NG:
the wall outlet prior to servicing. Failure to do so can result in
electrical shock!
5 Amp Circuit Breaker
1. Remove the hex nut securing the circuit breaker to the base.
2. Pull the circuit breaker through the inside of the base until it is free.
3. Disconnect the two wires from the circuit
breaker.
4. Insert the new circuit breaker into the base
(fro m the inside towards the outside) and
secure it in place with the hex nut.
5. Reconnect the two wires to the rear of the
circuit b reaker.
15 Amp Fuse Holder Assembly
1. Remove the hex nut securing the
fuse holder to the base.
2. Pull the fuse holder through the
outside of the base until it is free.
3. Disconnect the two wires fro m
the fuse holder.
4. Insert the new fuse holder into
the
base
towards the inside) and secure it
in place with the hex nut.
5. Reconnect the two wires to the
rear of the fuse holder.
Replacing the 15 Amp Fuse
1. Insert the end of a blade screwdriver into the fuse holder cap.
2. Turn the fuse holder cap until it pops loose and remove it.
3. Remove the blown fuse fro m the fuse holder cap and install a new one.
4. Replace the fuse holder cap and turn it with a b lade screwdriver to
lock it in place.
Replacing Major Components
The service cord MUST be disconnected from
(fro m the
outside
61
Publicité
