Publicité
Les langues disponibles
Les langues disponibles
Replacing Major Components
Water Reservoir
1. Drain the water fro m the coffee maker (see
2. Remove the in let tubing connected on the brewer side of the reservoir.
3. Remove the outlet tubing connected to the bottom of the reservoir.
4. Disconnect the float switch wiring (in line connector).
5. Remove the large screw securing the front of the reservoir to the support.
6. Remove the other large screw securing the side of the reservoir to the
support.
7. Remove the water reservoir.
8. Install the new reservoir and secure it in place with the two screws.
9. Reconnect the inlet tubing on the brewer side of the reservoir.
10. Reconnect the outlet tubing to the bottom of the reservoir.
11. Install a new rubber gasket to the top of the reservoir.
NOTE:
When any component of the water system is replaced, a quick-rinse
cycle must be performed to purge air out of the system.
48
page
38).
Publicité
