VKI Technologies Espresso Cafe Manuel D'opération page 41

WARNI NG:
disconnect the service cord and drain the water system prior
to servicing the equipment.
WARNI NG:
Espresso Café are low voltage (and not 120 volts AC). Never
connect these electrical components to 120 volts AC.
Opening the Cover
Opening the cover allows access to the interior of the Espresso Café. Some
maintenance or service can be performed with the cover open, but in other cases the
cover needs to be removed comp letely (see
Panel" on page 42).
1. After unplugging the service cord, open the milk door and remove the milk
canister, then open the water door.
2. Opening the doors exposes the screws securing the cover to the coffee
maker's mainframe. Remove these two screws (figure 1).
3. Lift the front of the cover until it is completely open (figure 2). The h inges
at the rear of the cover will keep it open.
Figure 1
NOTE:
When closing the cover, it may be necessary to press down slightly
on the left and right sides of the cover while tightening the screws, otherwi s e
the two doors may not close properl y .
Replacing Major Components
Switch OFF the power to the coffee maker,
The majority of the electrical components in the
"Remov ing the Cover and Contour
Figure 2
41