Publicité
Les langues disponibles
Les langues disponibles
WARNING:
be extremely hot and can cause severe burns. The water system must
be
drained
Outlet Valves
1. Drain the water fro m the coffee maker (see
2. Disconnect the wiring fro m each valve co il (three pairs of wires).
3. Disconnect the tubing from the outlets of the hot water and milk valves.
4. Remove the coffee tubing at the brewer head by opening the plastic clip.
5. Disconnect the large fitting fro m the heater assembly.
6. Lift the valve assembly up and out.
7. Place the new outlet valve assembly in position.
8. Connect the large fitting to the heater assembly.
9. Connect the tubing going to the whipper bowl.
10. Connect the coffee tubing (part of the outlet valve assembly) to the brewer
head and secure it in place with the plastic clip.
11. Connect the wiring to each of the valve coils (three pairs of color coded
wires).
White Wires
Milk Valve
NOTE:
The outlet valves are available only as an assembly (three val v es
with fittings installed). Individual valves are not available.
NOTE:
When any component of the water system is replaced, a quick-rinse
cycle must be performed to purge air out of the system.
Replacing Major Components
Use caution when servicing the outlet valves as they m ay
before servicing this component.
Blue Wires
Water Valve
page
38).
Red Wires
Coffee Valve
51
Publicité
