Publicité
Les langues disponibles
Les langues disponibles
Replacing Major Components
Removing the Cover and Contour Panel
For many repair procedures, removing the cover provides sufficient access to coffee
maker co mponents. For greater access to components, the contour panel can also be
removed.
Removing the Cover
1. After unplugging the service cord, open the milk door and remove the
milk canister, then open the water door.
2. Opening the doors exposes the screws securing the cover to the coffee
maker's mainframe. Remove these two screws.
3. Lift the front of the cover until it is completely open. The hinges at the
rear of the cover will keep it open.
4. Disconnect the wiring harness from the <
System Status LED panel. Disconnect the inline connector for the milk
door IR sensor.
5. Remove the wiring fro m the routing clips built into the underside of the
cover.
6. Pull the cover forward then lift it upwards to remove it fro m the quick-
release hinges.
NOTE:
When closing the cover, it may be necessary to press down slightly
on the left and right sides of the cover while tightening the screws, otherwi s e
the two doors may not close properl y .
42
> button board and the
START
Publicité
