Publicité
Les langues disponibles
Les langues disponibles
7. Carefully insert the screwdriver into the conveyor through the small grill
where the milk can ister would sit (figure 6).
8. Position the end of the screwdriver against the auger (spiral) inside the
conveyor to prevent it fro m turning (figure 6a).
9. Insert a quarter (coin) into the coupling at the bottom of the conveyor.
Figure 6a
Figure 6
10. With the screwdriver jamming the auger in place, turn the auger coupling
clockwise to loosen it. Once it is loose, it can be removed by hand by
turning it clock wise until it co mes off.
11. Once the coupling is removed, remove the screwdriver fro m the grill and
turn the conveyor assembly upside down. The auger will now slide out of
the conveyor.
NOTE:
There is a small O-ring at the base of the auger (see figure
6a). Be very careful not to lose this O-ring as it must be re-installed
prior to re-assembling the conveyor.
Cleaning the Milk Conveyor
O-Ring
35
Publicité
