Publicité
Les langues disponibles
Les langues disponibles
Software Features
Switch OFF the power and connect the handheld programmer to the coffee maker
- use the <
SCRO LL UP
software.
NOTE:
Product and water setti n gs are cali b rated when the coffee maker i s
manufactured at the factory. These settings cannot be changed (except for setting
a 6 or 7 fl . oz cup) as no adjustments are required on thi s equipment.
Software Menu Navigation
MA IN MEN U
E m pt y cy cl e
P re ss st ar t
20
> and <
SCRO LL DOWN
SUB MENU
Emp ty milk
Press start
Close milk
Door
Emp tying
Please wait
rem ove
mil k ca ni ste r
Emp ty water
Press start
Emp tying
Please wait
Instal l drain
insert - star t
Emp tying-power
Off when done
> buttons to navigate through the
Pr o ce d u re
Press green <
START
enter menu.
Remove milk canister and press
START to empty the conveyor.
The milk door must be closed to
continue this cycle.
Wait until the cycle is complete.
*
If the milk canister has not
been removed, this reminder
appears on the display.
Disconnect the water supply
from the coffee maker. When
the "
" cycle is
EMPTY MILK
complete, this message appears
on the display. At this point,
place the waste bin under the
dispensing spout.
Water will be dispensed from
the spout, into the waste bin.
Wait until the cycle is complete.
Install the drain insert to the
drain plug underneath the coffee
maker. Press START to drain
the remaining water from the
water heater.
Wait until the cycle is complete,
switch the coffee maker power
OFF and disconnect the service
cord from the power outlet.
> button to
Publicité
