Publicité
Les langues disponibles
Les langues disponibles
Replacing Major Components
NOTE:
From this point forward, it i s assumed the coffee maker cover and/or
contour panel is removed for servicing and pow er i s OFF. Once service is
complete, re-install the coffee maker cover and contour panel.
Brewer
With the cover already open:
1. Disconnect the wiring harness connector from the brewer circuit board.
2. Disconnect the brewer motor harness.
a) Open the two clips securing the harness to the support and remove
the brewer wiring.
3. Remove the screw securing the left side of the brewer to the mainframe.
4. Lift the front of the brewer and pull the brewer straight up and out (note
that the right side of the brewer is secured to the main frame by snap clip).
5. Insert the new brewer assembly making sure the right side snaps into the
mainframe. Secure the left side to the mainframe with a screw.
6. Reconnect all wiring harnesses.
Brewer Heads
With the brewer in the open position:
1. Grasp the front and rear of the inlet or outlet
head.
2. Pull the head straight up and out of the brewer.
3. Disconnect the tubing on the inlet head
by opening the plastic clip and pulling
off the tubing.
4. Prior to re-installing the brewer head
assemblies, insert the brew hose into
the pour spout.
5. Align and push the brewer heads into
position.
44
Publicité
