Publicité
Les langues disponibles
Les langues disponibles
Removing the Contour Panel
7. Remove the drip tray and rotate the coffee maker 90 degrees.
8. Fro m the rear of the coffee maker, remove the two screws located at the
exterior bottom of the contour panel.
9. Remove the screw above the bridge mount at the interior top of the
contour panel (inside center of panel).
10. Remove the two screws securing the contour panel to the mainframe.
These screws are located at the outer side of both flip door areas.
11. Slide the contour panel towards the rear until it is free fro m the
mainframe.
NOTE:
The tw o doors are simply snapped into place on the mainframe. No
tools are required to install replacement doors.
Replacing Major Components
43
Publicité
