VKI Technologies Espresso Cafe Manuel D'opération page 31

Emptying the Milk and Water Using the Cleaning Tab
This cycle must be performed prio r to cleaning the milk conveyor. It is
recommended that a Wet/Dry vacuum cleaner (Shop-Vac type) is available to
completely remove the milk fro m the conveyor.
CAUTION:
If only a cleaning is required, make certain the green side of the cleaning
tab is facing you.
1. Remove the milk canister fro m the mach ine.
2. Insert the cleaning tab into the pod slot (must be inserted all the way
down) with the red side of the tab facing you.
3. Position the selection handle between two selections (the green light will
switch off).
4. Pull out the waste bin and place it below the dispensing area.
5. Press the green <
the cycle.
6. The mach ine will now dispense milk fro m the milk tube until the
conveyor is empty.
7. Once the milk system is empty, the cold water reservoir will also be
emptied (fro m the water tube at the dispensing area).
8. When the cycle is comp lete, the green <
indicate that the water heater is ready to be emptied.
9. Empty the waste bin, and place the bin on the floor near the rear of the
mach ine.
10. Connect the drain insert to the drain fitting underneath the right rear
corner of the machine base. Place the drain insert hose into the waste bin
(which should be on the floor).
11. Press the green <
12. Empty and re-install the waste bin, and remove the cleaning tab.
13. If a Wet/Dry vacuu m is available, insert the vacuum nozzle into the milk
canister receptacle and switch the vacuum on. Leave the nozzle in place
for several minutes to remove any residual dehydrated milk fro m the
system.
Using the Cleaning Tab
This procedure will empty the milk from the Espresso Cafe.
> button for approximately 5 seconds to activate
START
> button to drain the water heater.
START
> button will flash to
START
31