Publicité
Les langues disponibles
Les langues disponibles
Removing the Coffee Maker
Drain the Water (Reservoir and Heater)
If continuing from the "
proceed directly to step #4.
1. Disconnect the water source (if applicable).
2. With the power OFF, remove the waste bin and connect the programmer to
the coffee maker and switch the power ON.
3. Scroll to the "
the display reads "
4. Place the waste bin below the dispensing spout.
5. Press <
START
EMPTYING – PLEASE WAIT
"
6. When reservoir is empty, the display will read "
START
". Install the drain insert into the drain fitting underneath the base.
a)
Carefully position the coffee maker so that only the right rear leveler
is 'hanging' from the end of the countertop.
b) Locate the drain fitting beside the right rear leveler and place the
waste bin directly under it.
c)
While pressing the lock latch, install the drain insert into the fitting
and lock it in place by releasing the lock latch.
7. Press the <
draining from the insert.
8. The display now reads "
is emptied, switch off the power to the coffee maker.
9. Remove the drain insert and disconnect the service cord from the wall outlet.
38
EM PTY THE MILK CON VEYOR
EMPTY CYCLE
" menu and press <
EMPTY WATER – PRESS START
> to activate the cycle. The message on the display now reads
".
> button to activate the drain cycle. Water will now start
START
emptying – power off when done
" section on the previous page,
>. Scroll again until
START
".
INSTALL DRAIN INSERT –
". Once the water
Publicité
