Publicité
Les langues disponibles
Les langues disponibles
Water Level Float Switch
1. Loosen and remove the plastic hex nut securing the switch to the reservoir
– located at the outside bottom of the reservoir.
2. Using wire cutters, cut the two float switch wires at the inline connector
and discard the connector.
3. Fro m the inside of the reservoir, pull the switch straight out.
4. Remove the o-ring installed between the float switch and the water
reservoir. The o-ring may be stuck the bottom of the float switch or it may
have fallen into the water reservoir.
5. Pass the wiring fro m the new switch fro m the inside of the reservoir to the
outside (so it is coming out the bottom).
6. After making sure the o-ring is installed on the bottom of the float switch,
secure the switch into the bottom of the reservoir with the plastic hex nut.
Hand-tighten only as over-tightening will strip the threads.
7. Insert the wiring terminals into the connector provided.
8. Reconnect the inline connector.
Replacing Major Components
NOTE:
Once the float switch wires are cut from the connector, the
switch can no longer be used and must be replaced w ith a new one.
NOTE:
Insert the w ires into the connector only after they have
been passed through the bottom of the reservoir.
Install the connector only
after the float is installed
inside the reservoir.
49
Publicité
