Publicité
Les langues disponibles
Les langues disponibles
Should the coffee maker need to be relocated or removed for any reason, the milk
system and the water system must be purged (emptied) beforehand. This is
especially impo rtant if the coffee maker is to be transported to another location.
WARNING:
the "empty milk" cycle.
Empty the Milk Conveyor
1. Switch OFF the power to the coffee maker.
2. Remove the milk canister.
3. Remove the waste bin.
4. Connect the programmer to the coffee maker (see
Programmer" section).
5. Switch the power ON.
6. Scroll to the "
the display now reads "
7. Place the waste bin at the dispensing spout area.
8. Press <
START
EMPTYING – PLEASE WAIT
reads "
NOTE:
throughout the entire procedure. If the door is opened, the auger will
stop.
9. Once comp lete, the coffee maker will automat ically proceed to the
EMPTY WATER
"
10. Using a Shop-Vac type vacuum, p lace the vacuum nozzle d irectly over
the milk can ister receptacle (the grill onto which the milk canister lid
check valve engages).
11. Switch
vacuum to pull any remain ing milk fro m the conveyor system.
NOTE:
The next time the milk canister is re-inserted (after running the
"
EMPTY MILK
completely refill the conveyor.
Removing the Coffee Maker
Do not install the drain insert into the drain fitting during
EMPTY CYCLE
EMPTY MILK
> to activate the cycle. The message on the display now
As a safety precaution, the milk door must remain closed
" menu.
the vacuum and allow appro ximately one minute for the
ON
" cycle), di s pense two cups of Caffè Latte or Cappuccino to
" menu and press <
".
".
"Connecting the
>. The top line of
START
37
Publicité
