Keysight Technologies 3458A Guide D'utilisation page 74

3 Configuring for Measurements
Introduction
This chapter shows how to configure the multimeter for all types of measurements
except digitizing.
memory, the input buffer, and the status register. After using this chapter to
configure the multimeter for your application, you can then use
how to trigger readings and transfer them to reading memory or the GBIB output
buffer. The major sections in this chapter are:
– General Configuration
– Configuring for DC or Resistance Measurements
– Configuring for AC Measurements
– Configuring for Ratio Measurements
– Using Subprogram Memory
– Using State Memory
– Using the Input Buffer
– Using the Status Register
[1] This chapter doesn't address digitizing specifically although most of the information under
74
[1]
This chapter also shows you how to use subprogram and state
General Configuration does apply to digitizing. Refer to
digitizing.
Chapter 4
Chapter 5 for specific information on
Keysight 3458A User's Guide
to learn