Keysight Technologies 3458A Guide D'utilisation page 31

Initial Inspection
If any of the following symptoms exist, or are expected, remove the
WARNING
multimeter from service:
– Visible damage.
– Severe transport stress.
– Prolonged storage under adverse conditions.
– Failure to perform intended measurements or functions.
Do not use multimeter until safe operation can be verified by service trained
personnel.
The multimeter was carefully inspected before it left the factory. It should be
undamaged and in proper working order upon receipt. If the shipping container or
cushioning material is damaged, keep it, until the contents of the shipment have
been checked and the multimeter has been inspected. When you unpack the
multimeter, verify that the following items are included:
– Line Power Cord (Qty. 1)
– Replacement line power fuses: 500 mA T (Qty 1 for 220/240 operation), 1.5 A
– Keyboard Overlay (Qty. 5)
– Switch Lockout Caps (Qty. 2)
– Test Lead Kit (Qty. 1)
If the multimeter is damaged or the contents are incomplete, promptly notify the
nearest Keysight Technologies office.
Keysight 3458A User's Guide
NTD (Qty 1 for 100/120 operation)
Installation and Maintenance 1
31