Keysight Technologies 3458A Guide D'utilisation page 66

2 Getting Started
The present AC voltage measurement method (SETACV RNDM) is displayed. At
this point, reset the multimeter to return it to the power-on state by pressing:
Digits displayed
When the multimeter is displaying readings, you can vary the number of digits it
displays. In the power-on state, the display is showing 7.5 digits although the
multimeter is resolving 8.5 digits. To display all 8.5 digits, press:
The display's leftmost digit (referred to as a 1/2 digit) is implied when you are
NOTE
specifying display digits.
The NDlG command only masks digits from the display. It does not affect readings
sent to reading memory or transferred over the GPIB bus. Also, you cannot view
more digits than are being resolved by the multimeter.
Recall
You can easily recall the last executed command without repeating the command
entry process. Press:
The display will show the last command executed. (You cannot recall commands
that are executed immediately such as Reset or DCV, or any command that
contained the calibration security code.) By repeating the above keystrokes, you
can recall previously executed commands. After recalling the desired command,
you can modify it (see
pressing Enter.
66
Reset
N
Offset 8
Comp Ω
Recall
Enter
Display editing
Enter
earlier in this section) and execute it by
Keysight 3458A User's Guide