Keysight Technologies 3458A Guide D'utilisation page 331

RESET
Allows you to set the multimeter to the power-on state without cycling power.
Syntax
RESET
Remarks
– The RESET command does the following:
Keysight 3458A User's Guide
Aborts readings in process.
Clears error and auxiliary error registers.
Clears the status register except the Power-on SRQ bit (bit 3).
Clears reading memory.
In addition, the RESET command also executes these commands:
ACBAND 20,2E6
AZERO ON
DCV AUTO
DEFEAT OFF
DELAY -1
DISP ON
EMASK 32767 (all enabled)
END OFF
EXTOUT ICOMP,NEG
FIXEDZ OFF
FSOURCE ACV
INBUF OFF
LEVEL 0,AC
LFILTER OFF
LFREQ (line frequency rounded to
50 or 60 Hz)
Command Reference
LOCK OFF
MATH OFF
MEM OFF (last memory operation
set to FIFO)
MFORMAT SREAL
MMATH OFF
NDIG 7
NPLC 10
NRDGS 1,AUTO
OCOMP OFF
OFORMAT ASCII QFORMAT NORM
RATIO OFF
RQS 0
SETACV ANA
SLOPE POS
SSRC LEVEL,AUTO
6
331