Keysight Technologies 3458A Guide D'utilisation page 68

2 Getting Started
command). For example, you can access and execute the string assigned to key f0
by pressing:
0
You can also assign commands from the command menu to user-defined keys.
You cannot assign a command using an immediate execute key (DCV, ACV, etc.)
Instead, you must access that command from the menu. Key definitions stored
from the front panel can be edited from the front panel. (You cannot edit a key
definition that was downloaded from the controller.) Editing is done by pressing
the user-defined key and, while the string is displayed, editing the string as
described under
press the Enter key to execute the string. (The previous string is still assigned to
the user-defined key.) An edited string cannot be re-assigned to a user-defined
key. If you want to change a key definition, you must repeat the above steps.
Installing the keyboard overlay
Figure 2-6
write on this overlay with a pencil to identify the command(s) assigned to each
user-defined key.
Figure 2-6
68
Enter
Display editing
shows the keyboard over-lay that fits over the USER keys. You can
Keyboard overlay (Keysight part number 03458A-84303)
earlier in this section. After editing the string,
Keysight 3458A User's Guide