Keysight Technologies 3458A Guide D'utilisation page 34

1 Installation and Maintenance
Installing the Multimeter
This section discusses the multimeter's grounding and power requirements and
contains instructions for installing the multimeter. (Refer to
instructions on how to install the switch lockout caps.)
multimeter's rear panel. Many of the rear panel connectors and switches are
referenced in this section.
Figure 1-1 Rear panel
Grounding requirements
The multimeter comes with a three-conductor AC power cable (see
The power cable must be connected to an approved three-contact electrical
outlet that has its ground conductor connected to an electrical ground (safety
ground). The multimeter's power jack and the supplied power cable meet
International Electrotechnical Commission (IEC) safety standards.
For protection from electrical shock, the power cord ground must not be
NOTE
defeated.
34
Appendix C for
Figure 1-1 shows the
Figure
Keysight 3458A User's Guide
1-3).