Keysight Technologies 3458A Guide D'utilisation page 413

ABORT 7 (IFC)
Clears the multimeter's interface circuitry.
Syntax
ABORT 7
Example
ABORT 7
CLEAR (DCL or SDC)
Clears the multimeter, preparing it to receive a command. The CLEAR command
does the following:
– Clears the output buffer.
– Clears the input buffer.
– Aborts subprogram execution.
– Clears the status register (bits 4, 5, and 6 are not cleared if the condition(s)
– Clears the display
– Disables triggering (the previous triggering mode can be resumed by sending
Syntax
CLEAR 7
CLEAR 722
Examples
CLEAR 7
CLEAR 722
Keysight 3458A User's Guide
!CLEARS THE MULTIMETER'S INTERFACE CIRCUITRY
that set the bit(s) still exist).
any multimeter command).
!CLEARS ALL DEVICES (DCL) ON THE BUS (SELECT CODE 7)
!CLEARS THE DEVICE (SDC) AT ADDRESS 22 (SELECT CODE 7)
GPIB Commands
413
B