ORSI Competition GS o-s 135 Instructions Originales page 113

PROBLEMS
Strange noises coming from the machine.
Excessive vibrations.
Irregular cut.
Overheating straps of transmission
Usury rapid utensils
6.6 TROUBLESHOOTING
POSSIBLE CAUSES
Poor lubrication bearing rotor.
Low oil gearbox.
Wrong speed of the taking of strength of the car.
Foreign bodies wrapped to the rotor.
Wrong speed of the taking of strength of the tractor.
Excessive consumption and irregular tool.
Knives worn or broken.
Unbalanced rotor
Damaged or broken utensils.
Belts lens.
Wrong position of the support roller, wheel or skids.
Wrong speed of the taking of strength of the tractor.
Straps slow or too tight
Forward speed too high compared to the chopping
material
Utensils that touch the ground
ENGLISH
REMEDY
Grease.
Top up.
To verify the speed of the taking of strength (540 or 1000
turns / min).
To remove the extraneous body.
To verify the speed of the taking of strength (540 or 1000
turns / min).
Replace tools including those opposed.
Replace tools including those opposed.
Contact an authorized center.
Replace tools including those opposed.
Tighten the belts.
To verify the alignment of the roll of support of the wheels
or of the sleighs.
To verify the speed of the taking of strength (540 or 1000
turns / min).
Check the belt tension
Reduce the speed of the tractor
Adjust cutting height by acting on the organs support the
tractor
Qualification
113