Technical Data - Siemens SITRANS TSinsert TS100 Notice De Service

With this declaration you warrant "that the device/replacement part has been carefully cleaned and is free of residues.
The device/replacement part does not pose a hazard for humans and the environment."
If the returned device/replacement part has come into contact with poisonous, corrosive, flammable or water-
contaminating substances, you must thoroughly clean and decontaminate the device/replacement part before returning it
in order to ensure that all hollow areas are free from hazardous substances. Check the item after it has been cleaned.
Any devices/replacement parts returned without a decontamination declaration will be cleaned at your expense before
further processing.
The forms can be found on the Internet as well as in the documentation which comes with the device.
7.3 Disposal
8

Technical data

8.1 Rated conditions
Storage
8.1.1 Maximum permitted ambient temperatures in the connection area of the sensor
8.1.1.1 SITRANS TS100
Note
Application SITRANS TS100
SITRANS TS100 temperature sensors are only approved for the temperature classes T4 and T6. Pay attention to the
temperature resistance of the connection cables.
See also
Potentially explosive gases - temperature classes T6, T4, T3 (Page 23)
Flammable dusts (Page 25)
8.1.1.2 SITRANS TS500
Potentially explosive gases - temperature classes T6, T4, T3
Calculation of the maximum permissible ambient temperatures for the electronics
The maximum permissible ambient temperature T
the respective certificate minus the thermal value ΔT2 from the following table.
Calculation of the maximum permissible ambient temperatures for the connection head
The maximum ambient temperatures T
cells in the following table while taking into account the corresponding temperature of the medium.
SITRANS TSinsert/TS100/TS200/TS300/TS500 (7MC71.. 7MC72.. 7MC80.. 7MC75.. 7MC65.. 7MC55..)
A5E03920348-AB, 03/2016
Devices identified by this symbol may not be disposed of in the municipal waste
disposal services under observance of the Directive 2012/19/EC on waste electronic
and electrical equipment (WEEE).
They can be returned to the supplier within the EC or to a locally approved disposal
service. Observe the specific regulations valid in your country.
Further information about devices containing batteries can be found at: Information
about battery / product return (WEEE)
(https://support.industry.siemens.com/cs/document/109479891/)
for the certified electronics used is calculated from the value present in
amb
for the respective connection head without electronics can be obtained from the
amb
-40 ... +80 °C (-40 ... +176 °F)
23