Table des Matières
Publicité
LOWR
ASSEMBLY AND ADJUSTMENT
Pinion gear shim
1. Assembly the pinion height gauge with
the drive shaft and bearing as shown in
the illustration.
Pinion height gauge:
90890-06702
NOTE:
Add a 1/4 turn to each of the butterfly nut
after it touches fixing plate.
2. Install the pinion on the drive shaft, and
tighten the nut to the specified torque.
Pinion nut:
50 Nm (5.0 m • kgf, 36 ft • lb)
3. Measure the Mv3 (measurement value
of between the pinion and pinion height
gauge).
Digital caliper:
90890-06704
4. Use the following equation to calculate
the pinion shim thickness (T3).
Shim thickness (T3) =
Mv3 – 29.3 – P/100 (unit: mm)
Available shim thicknesses:
0.05, 0.08, 0.12, 0.30, and 0.50
mm
NOTE:
If the P value is negative (–), then add the P
value to the measurement.
6-19
E
Publicité
Table des Matières
