Yamaha 25J Manuel D'entretien page 128

FUEL
OIL INJECTION
E41000-0
REMOVAL
1. Drain the oil from the oil-tank and
remove the carburetor.
2. Disconnect the hoses and remove the
oil-injection system.
E42000-0
CLEANING AND INSPECTION
Oil-tank
1. Using solvent, clean the oil-tank.
2. Drain the solvent and dry the tank.
3. Inspect the oil-tank for cracks, and
replace it if required.
Oil-level gauge
Refer to page 8-17.
Oil-hoses
1. Inspect the oil-hoses for damage or
cracks, and replace them if required.
E43003-1
INSTALLATION
1. Connect the oil-hoses to the oil-pump,
and tighten the clips on the hoses.
2. Install the oil-pump to the power-head.
3. Assemble the oil-tank and install it.
4. Connect the oil delivery-hoses to the
intake manifolds, and tighten the clips
on the hoses.
5. Install the carburetor.
6. Lead the wire of the oil-level sensor to
the starboard side of the engine, and
connect the cores.
4-11
E