Yamaha 25J Manuel D'entretien page 168

POWR
RECOIL STARTER
Starter spring
1. Visually inspect the starter spring and
replace it if it is broken or has distorted
ends.
Start-in-gear protection
1. Inspect the starter stop-plunger and
replace it if is cracked or damaged.
2. Inspect the cable and replace it if it
shows signs of fraying or sticking.
H13000-1
ASSEMBLY
1. Hook the outer end of the starter-spring
onto the retainer-post attached to the
starter-case, and install the spring onto
the starter case by winding it counter-
clockwise.
Water resistant grease
NOTE:
Apply water resistant grease to the inner
surface of the starter case.
Each new starter-spring is bound by a
steel hoop. To install, hook its outer end
onto the retainer-post first, put it into the
starter case, and then remove steel hoop.
2. Insert the rope through the rope-holes,
and knot the ends.
5-18
E