Table des Matières
Publicité
LOWR
ASSEMBLY AND ADJUSTMENT
4. Using feeler gauges set at the specified
measurement (M) established above,
check the fit between the shimming
gauge and the reverse gear. Force the
shimming gauge against the shims and
thrust washer when checking the fit.
5. If the feeler gauge(s) will not fit, then
add additional shims until the feeler
gauge(s) (set at the M specification) just
fit between the tool and the gear.
6. If the feeler gauge(s) are a loose fit, then
remove shims until the feeler gauge(s)
(set at the M specification) just fit
between the tool and the gear.
Available shim thicknesses:
0.05, 0.08, 0.12, 0.30, and 0.50
mm
SHIM SELECTION
(Except for USA and CANADA)
NOTE:
When reassembling the lower unit with
the original gear case and inner parts,
shim selection is not required.
When replacing the gear case only, read
the numeral preceded by "F, R, P", and
adjust the shims according to the differ-
ence between numerals of the original
gear-case and the new gear-case.
If the bearing(s) and/or gear(s) are
replaced, carry out the shim selection.
6-18
E
Publicité
Table des Matières
