Yamaha WaveRunner FX140 Manuel D'entretien page 728

HULL
HOOD
ENGINE MOUNT
2. To prevent water from entering the ure-
thane foam, apply silicone sealant to the
inside of the hole as shown.
3. Install the insert nut as explained in
"Example 1".
• Brass insert nut 1
• Hull 2
• Urethane foam 3
• Silicone sealant 4
Graphic removal
1. Hold a hair dryer approximately 1.5 inches
above the graphic 1.
2. Apply heat to one corner of the graphic.
3. Slowly peel off the heated portion of the
graphic and continue working until you
reach the opposite corner and the entire
graphic is removed.
4. After the graphic is removed, clean the
entire bow area with isopropyl alcohol to
remove any residual adhesive.
Graphic installation
1. Mix 1 tablespoon of liquid detergent and
water in a 1-quart spray bottle.
2. Remove the backing from the new
graphic.
3. Spray the soap and water mixture onto
both sides of the graphic, and also onto
the hull area where the graphic will be
installed.
NOTE:
Spraying the front of the graphic with the soap
and water mixture will protect it from being
scratched during installation.
4. Align the graphic onto the fitting area of
the hull and position it with a squeegee.
NOTE:
Be sure to remove any air bubbles from the
graphic with the squeegee. Work from the top
of the graphic down and slide the squeegee
outwards from the graphic's center line.
5. Allow the graphic to dry before waxing or
using the watercraft.
8-54
E