Yamaha WaveRunner FX140 Manuel D'entretien page 102

INSP
ADJ
CONTROL SYSTEM
2. Adjust:
• Throttle lever free play
Adjustment steps:
NOTE:
• When not replacing the throttle cable or
removing the cable from the throttle body,
adjust the throttle cable free play by fol-
lowing steps (f) through (j).
• When replacing the throttle cable or
removing the cable from the throttle body,
adjust the throttle cable free play by fol-
lowing steps (a) through (k).
a. Remove the air filter case cover 1 and
flame arrester.
b. Pull back the cover 2.
c. Loosen the locknut 3.
d. Turn the adjusting nut 4 to adjust the
length a.
Throttle cable installation length:
18.4 ± 1.0 mm (0.72 ± 0.04 in)
NOTE:
Apply locking agent (LOCTITE
threads of the adjusting nut 4.
e. Push in the cover 2.
f. Remove the handlebar cover.
g. Loosen the locknut 5.
h. Turn the adjuster 6 in or out until the
specified free play is obtained.
Turn in
Turn out
i. Tighten the locknut.
NOTE:
• When adjusting the throttle cable at the
throttle body, fully open the throttle lever
and check that the butterfly valve is fully
open.
• If the throttle cable free play cannot be
adjusted properly, replace the throttle
cable.
3-4
®
) to the
Free play is increased.
Free play is decreased.
E