Yamaha WaveRunner FX140 Manuel D'entretien page 368

POWR
b
c
VALVES AND VALVE SPRINGS
b
60˚
45˚
4. Use a 60° cutter to adjust the contact width
of the bottom edge of the valve seat.
b Previous contact width
5. Use a 45° cutter to adjust the contact width
of the valve seat to specification.
b Previous contact width
c Specified contact width
6. If the valve seat contact area is too wide
and situated in the center of the valve
face, use a 30° cutter to cut the top edge
of the valve seat, a 60° cutter to cut the
bottom edge to center the area and set its
width.
b Previous contact width
7. If the valve seat contact area is too narrow
and situated near the top edge of the valve
face, use a 30° cutter to cut the top edge
of the valve seat. If necessary, use a 45°
cutter to center the area and set its width.
b Previous contact width
8. If the valve seat contact area is too narrow
and situated near the bottom edge of the
valve face, use a 60° cutter to cut the bot-
tom edge of the valve seat. If necessary,
use a 45° cutter to center the area and set
its width.
b Previous contact width
5-74
E