HBM PMX Manuel D'emploi page 479

Jeu de commandes
SAD?
Syntax 1: SAD?(x)
Parameter: none
Response: q1,q2(y)
q1 Excitation voltage (or current), see SAD command tables
q2
p3
e.g. PX401: 10,426,-1:10,427,-1:....
Syntax 2: SAD??(x)
Parameter: none
Response: q1,..,qn(y): possible excitation voltage or similar as per table 1
to 4 (SAD-Command)
e.g. PX401: 10,10,10:10,10,10:
Syntax 3: SAD?,?(x)
Response: q1..qn(y): possible transducer type as per table 5 (SAD com-
mand)
e.g. PX401: 426,427,435: 426,427,435:...
Virtual subchannels (channel 9) return values q1=10, q2=575.
CDT
Enter target value for zero displacement of input characteristic (for CDV com­
mand) for all selected channels (PCS / SPS).
Syntax: CDTp1(x)
Parameter: p1:
value
Effect: value in displayed units to which the amplifier is to be set with
the CDV command(no parameters). Factory setting 0.
Note: Response depends on SRB command.
A3257−2.0 en/de/fr
Sensor Adaption Query
Output set transducer adaptation for all selected channels (PCS /
SPS)
Transducer type, see SAD command table 5
Sensitivity (-1 if not supported/needed) , see table 6
Calibration Dead Load Target
target value should be set to that of current measured
1 to 4
143