HBM PMX Manuel D'emploi page 129

Commands
MBF
This command establishes the RMB output format. The query command re-
turns the currently set format.
Syntax: MBFp1,p2(x)
Parameter: p1:
1257 4 bytes binary (Float) INTEL (physical size) other
formats are not supported
With floating formats, an error (overflow / calibration error) is
coded by 2e20.
p2: 0,..,2 measurement rate group
If parameter p2 is omitted, the setting affects all measurement rate groups.
Note: Response depends on SRB command.
MBF?
Syntax: MBF? p1(x)
Parameter: p1: 0,..,2 measurement rate group
Response: q1(y)
q1: Output format
If parameter p1 is omitted, you are given the output format of measurement
rate group 0.
A3257−2.0 en/de/fr
Measuring Buffer Format
Measuring Buffer Format Query
129