Pmx Parameterization With Teds - HBM PMX Manuel D'emploi

57
Electrical connection
The TEDS Editor "scans the TEDS module and indicates its readiness for
"
programming (also see the HBM brochure:TEDS data memory in the trans-
ducer − content and data memory editing).

7.6.3 PMX parameterization with TEDS

If a transducer with TEDS is connected, and contains the
parameterization data for a sensor, this can be used to automatically
parameterize the PMX.
The PX455 measurement card has a 0-wire TEDS. The sense leads of the
sensor cable are used to address the TEDS chip.
In the PX401 measurement card, the TEDS chip is addressed separately, via
an additional connection (1-wire TEDS).
When the PMX is switched on, it automatically detects whether a sensor with
TEDS is connected. Die Daten werden ausgelesen und der Verstärkerkanal
damit parametriert. When the transducer is replaced in the switched-on state,
the new TEDS is also detected automatically, but has to be activated manu-
ally.
A3257−2.0 en/de/fr