HBM PMX Manuel D'emploi page 127

Commands
TSV
Syntax: TSVp1 (x)
Parameter: p1: 0, 1,..,N number of value lines to be measured in a single
measurement:
1...N
0
-1
This allows the user to get ONE line (RMB?1,...) with the
latest measured data without the need to start a new meas-
urement permanently. Not yet fully tested if the values of the
different subchannels are taken exactly at the same time.
Note: Response depends on SRB command. Clears "overrun"
statusbit, see TSV?­query
TSV?
Syntax: TSV? p1(x)
Parameter: p1: measurement rate group; 0, 1, 2
Response: q1, q2, q3 (y)
q1: number of measurement lines in the FIFO buffer that
have not been sent.
q2: trigger status of the current measurement
2: Measurement active (wait for stop)
3: Measurement terminated (default)
q3: status bits
Bit 0, (value=1): FIFO buffer overrun, will be cleared by next
TSV-command
Bit 1, (value=2): not yet used
Bit 2, (value=4): not yet used
Bit 3, (value=8): not yet used
Bit 4, (value=16): not yet used
A3257−2.0 en/de/fr
Transient Setup Values
This command defines and starts data acquisition.
³ max. fifo-size 15MB per meas rate group
means infinite. ³ default fifo-size 5MB per
meas rate group
means infinite with fifo-size of 1 line.
Transient Setup Values Query
Dieser Befehl definiert und startet die Datenerfassung.
127