HBM PMX Manuel D'emploi page 122

122
SMS
This command sets the subchannel selection mask for the recording. The
channels (= PMX slots) to be set should already be selected with PCS.
Syntax: SMS p1,.., p128 (x)
Parameter: p1,.., p128 1,.., 128 subchannel selection
SMS 0 (x) selects all the existing subchannels
Note: Response depends on SRB command.
SMS?
Syntax: SMS?p1(x)
Parameter: p1:
0 existing subchannels
1 selected subchannels
Response: q1,.., q128 list of the existing or active ML channels
MSS
This command selects the signals to be recorded of the channels selected
with PCS / SPS. It is possible to select different signal combinations for the
various channels. In particular, it is possible to record more than one signal for
each subchannel.
Syntax: MSS p1, p2, p3, p4 (x)
p2...p4 are optional.
Called without parameters the selected subchannels are set to gross.
Subchannel Measurement Select
Unterkanalmaske für die Aufzeichnung wählen
Subchannel Measurement Select Query
Query subchannel mask for recording.
output mode
Subchannel Measurement Select
Commmands
A3257−2.0 en/de/fr