Operating Data - Ecolab EcoAdd Manuel D'utilisation

Control / Software
7.12

Operating data

Here all operating data since commissioning or since the last reset of the metering pump
can be retrieved. All operating data is stored for a maximum of 1 year.
Fig. 75: Operating data
1. [Call up the Main menu] :
2. [Select Configuration] :
3. Using the scrollbar on the right side of the screen, scroll to the [Operating data] .
4. [Select Operating data] .
ð The screen changes to [Operating data].
5. Select the required 'Operating data' :
n Quantity
n Motor runtime
n Vessel change
n Alarms
n Service
Press start
n
n Pulse mode
n Reset?
ð Screen switches to the required 'Operating data' .
6. If the menu item 'Operating data' 'reset?' has been selected, a red screen is
displayed. There are two function buttons in the header.
Press the
The data remains saved.
ð The screen switches back to the overview of the 'Operating data'
7.
Press the
point.
ð The screen switches back to the overview of the 'Operating data'
8. By pressing the
9.
By pressing the
417102276 Rev. 5-02.2020
3
4
Ä Chapter 7.7 'Main menu' on page 73
Ä Chapter 7.10 'Overview - Configuration' on page 92
button to cancel the reset operation.
button to delete all the operating data that has been saved up to that
button, you can return to the [main menu].
button, you can return to the [operating display].
5
128
5