Ecolab EcoAdd Manuel D'utilisation page 287

1. [Call up the main menu] :
2. [Operating mode] - [Pulse] .
3.
[Click Next] to save the setting.
ð Screen change for the setting: 'Pulse interval' .
4. Enter pulse interval (ml, l / pulse) of the flowmeter being used.
5. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
6. Set the decimal point with the scrollbar.
7. Press the button
ð Screen changes to the 'pulse memory' query.
8. Select whether the 'pulse memory' is to be used.
ð If the 'pulse memory' has been selected, a
9.
Press the button
ð The screen switches to the setting for the 'Concentration' .
10. Enter solution concentration (% / ppm) of the flowmeter being used.
11. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
12. Set the decimal point with the scrollbar.
13. Press the button.
ð Settings are saved, and the screen returns to the overview of the
[Operating mode] .
14. Press the
button.
ð The screen switches back to the overview [Main menu] .
15. Press the button.
ð The screen switches back to the [operating display] .
16. Press and hold the displayed concentration value (% / ppm) for approx. 3 seconds.
ð The configuration page for changing the unit (% / ppm) is displayed.
17. Slightly tap the desired unit (% / ppm) of the concentration setting and select the
required unit.
18. Press the
button.
ð The screen switches back to the concentration setting.
19. If necessary, adjust the concentration value once again with the newly set unit.
20. Press the button.
ð The screen switches back to the [operating display] and displays the newly set
unit.
Ä Chapter 7.7 'Main menu' on page 73
Next.
Next.
85
Control / Software
is set in the selection box.
417102276 Rev. 5-02.2020