Batch] - [Initial Concentration] - Ecolab EcoAdd Manuel D'utilisation

7.10.12.3 [Batch] - [Initial concentration]

Fig. 68: Batch - [Initial preparation]
1. [Call up the Main menu] :
2. [Select Configuration] :
3. Use the scrollbar to scroll to the [menu item Batch] .
4. [Select Batch] .
ð Screen switches to the selection level [Batch]
5. 'Select Initial concentration' .
ð The option field 'Initial concentration' is marked.
6. [ Click Next]
ð Screen change for the setting: 'Initial concentration' / 'Water quantity' .
7. Enter the quantity in litres using the scrollbar.
8.
[ Click Next]
ð Screen change for the setting: 'Initial concentration' / 'Concentration' .
9. Enter the concentration in percent (%) using the scrollbar.
10. 'Select concentration after the decimal point' .
11. Enter the concentration in percent (%) (after the decimal point) using the scrollbar.
12. [ Click Next]
ð Screen change for the setting: 'Initial concentration' / 'Metering time' .
13. Enter the metering time in minutes using the scrollbar.
14. Press the
ð The setting is saved, and the screen switches back to the batch overview.
15. Press the
16. By pressing the
17. By pressing the
4
3
10
9
Ä Chapter 7.7 'Main menu' on page 73
Ä Chapter 7.10 'Overview - Configuration' on page 92
to save the setting.
to save the setting.
to save the setting.
button.
button to return to the menu: [Configuration].
button, you can return to the [main menu].
button, you can return to the [operating display].
6
5
12
11
117
Control / Software
8
7
14
13
417102276 Rev. 5-02.2020