Initial Start-Up - Ecolab EcoPro Manuel D'utilisation

Commissioning
7.1

Initial start-up

4
6
Fig. 16: Control elements 'EcoPro'
1 Rotary button for stroke adjustment
2 Locking mechanism for fixing the rotary button in place
3 LED - Alarm signal, colour: red flashing
4 LED - Metering mode "low", colour: Yellow
LED - When starting the pump: green (standby)
1. Install the mounting plate and pump in the required location and installation scenario.
Ä Chapter 6 'Mounting and installation' on page 31
2. Make the hydraulic connections.
Ä Chapter 6.3.1 'Hydraulic Installation' on page 36
3. If necessary, make the electrical connections for signal inputs.
Ä Chapter 6.4 'Electrical installation' on page 45
4. Connect the mains plug (fitted at the factory) to the power supply.
5. Use the 'ON/OFF button'
6. Reset viscosity by pressing the 'Push the ON/OFF' and 'Test '
buttons simultaneously (for approximately 3 seconds).
ð The LED that corresponds to the selected viscosity briefly flashes green (Fig. 16).
7.
Switch on the pump by pressing the 'ON/OFF button'
ð The pump resumes operation and the LED for the new viscosity setting flashes
(Fig. 16).
8. Perform calibration on initial commissioning:
Ä Chapter 7.3 'Calibration on initial start-up' on page 52
417102264 Rev. 6-12.2019
The enabled viscosity (high or low) is indicated by an LED display when the
pump is switched on.
Meaning of the LED colours:
1
2
n LED - Metering mode "low" (left):
– Permanently on when the pump is started, colour: green (standby).
3
5
– Flashing when operated in "low" metering mode, colour: yellow.
7
n LED - Metering mode "high" (right):
– Flashing when operated in "high" metering mode, colour: yellow.
.
5 LED - Metering mode "high", colour: Flashing yellow
6
'ON/OFF button'
7 Test button
8 Cable bushing for the mains connection cable
50
.