Stand Mounting Or Floor Mounting - Ecolab EcoPro Manuel D'utilisation

Mounting and installation
6.2.1

Stand mounting or floor mounting

1
Fig. 7: Preparations for stand mounting
Only fastening elements may be used for stand mounting with the
marking 1 (Fig. 7, Pos. 2).
1. Turn the mounting plate over
2. Insert fastening elements from behind into the four openings marked "table"
(= table/stand mounting) and engage into position.
3. Turn the mounting plate over again and hold it against the required mounting
position.
4. Using mounting plate as a template, mark the required boreholes with a sharp pencil
(Fig. 7, Pos. 4).
5. Make the holes.
6. When mounting the plate on a stony subsurface, use suitable dowels and screws to
fix the mounting plate in place.
For table mounting, fix the mounting plate in place using screws with 5 mm diameter.
7. Place the pump onto the mounting plate.
8. Slide the pump backwards along the mounting plate until it engages with an audible
click.
9.
10. Attach the connecting lines (hydraulic and electric):
Ä Chapter 6.3.1 'Hydraulic Installation' on page 36
Ä Chapter 6.4 'Electrical installation' on page 45.
DANGER!
The mounting plate can also be mounted on a suitable container.
No new holes may be drilled here so as to prevent the metering medium
from offgassing. Only containers which have already been prefabricated
over threaded inserts for mounting pumps may be used.
417102264 Rev. 6-12.2019
2
By pressing down the retaining tab (Fig. 7, pos. 5) the pump can be
removed from the mounting plate.
4
3
4
5
34
4
4
8
7
5