Upgrade - From 'Ecopro' To 'Ecoadd - Ecolab EcoPro Manuel D'utilisation

Repair, conversion, upgrade
11.2.2

Upgrade - from 'EcoPro' to 'EcoAdd'

The 'EcoPro' pump version can be upgraded to a more user-friendly 'EcoAdd' version
with operating display and Bluetooth interface by replacing the grey control unit.
1
Fig. 32: Upgrade from 'EcoPro' to 'EcoAdd'
1. Undo the fastening screws on the control unit of the 'EcoPro' .
2. Put the control unit of the 'EcoPro' control unit by lifting it upwards.
3. Remove both connectors (3.1) from the base of the 'EcoPro' control unit.
4. Put the control unit of the 'EcoPro' .
5. Insert both connectors (3.1) into the appropriate receptacles on the underside of the
control unit of the 'EcoAdd' control unit.
6. Put the control unit of the 'EcoAdd' control unit on the pump housing.
7. Tighten the fastening screws on the control unit
(operating unit/upper part of the pump).
417102264 Rev. 6-12.2019
2
The screws are not secured against falling out!
Ensure that the screws do not become lost during disassembly and do
not use any screws other than those originally provided.
The connectors are "coded" on-site and can thus only be inserted into
the sockets in the correct position.
NOTICE!
The pump housing contains a seal for the control unit.
When placing the control unit on the pump housing, ensure that the
seal is free from contamination.
The tightening torque for the fastening screws on the control unit is
approx. 1 Nm. To prevent damage to the thread, we recommend
tightening the screws by hand.
3
3.1
78
7
6