Operation; Switching The Pump On/Off - Ecolab EcoPro Manuel D'utilisation

8

Operation

Personnel:
Protective equipment:
8.1

Switching the pump on/off

Fig. 17: Control elements 'EcoPro'
1 Rotary button for stroke adjustment
2 Locking mechanism for fixing the rotary button in place
3 LED - Alarm signal, colour: red flashing
4 LED - Metering mode "low", colour: Yellow
LED - When starting the pump: green (standby)
1. The pump is switched on and off via the 'ON/OFF button'
2. After the pump is switched on, the viscosity level can be selected:
Ä Chapter 8.3 'Setting / changeover of the viscosity' on page 54
n Operator
n Specialist
Chemical-resistant protective gloves
n
n Protective eyewear
n Safety shoes
8
4
6
Depending on the selected viscosity, either the left or the right LED
flashes yellow (left = low viscosity, right = high viscosity).
In the 'Stand-By mode' the corresponding LED is lit in green
depending on the viscosity level.
1
2
3
5
7
5 LED - Metering mode "high", colour: Flashing yellow
6 On/off switch
7 Test button
8 Cable bushing for the mains connection cable
53
Operation
(Fig. 17, Pos. 6).
417102264 Rev. 6-12.2019