6.3.1.2.3 Pipe And Hose Connection With Attachment Nipple And Hose Clamp - Ecolab EcoPro Manuel D'utilisation

Mounting and installation

6.3.1.2.3 Pipe and hose connection with attachment nipple and hose clamp

1
2
3
4
5
Fig. 12: Pipe and hose connection with attachment nipple and hose clamp
A Detail/Section: Illustration of individual part
1 Hose
2 Swivel nut
3 Cone
4 O-Ring
1. Cut hose (Pos. 1) straight.
2. Push the swivel nut (pos. 2) over the hose (pos. 1).
3. Push the hose clamp (6) over the hose (1).
4. Push the hose (pos. 1) onto the tapered part (pos. 3) up to the stop collar (detail A1).
5. Place an O-ring (pos. 4) in the groove of the suction or pressure valve (pos. 5).
6. Tighten the union nut (2) (detail B1).
7. Push the hose clamp (6) downward and tighten (detail B1).
417102264 Rev. 6-12.2019
A1
6
B1
42
5 Suction valve, pressure valve
6 Hose clip
A1 Pipe or Hose plugged on
B1 Valve connection: Target state after assembly