Connecting The Suction Pipe And Pressure Pipe; Electrical Installation - Ecolab Elados EMP II - E10 Notice Technique

6.1.2

Connecting the suction pipe and pressure pipe

When connecting the suction and pressure pipes, ensure that the O-rings (Pos.
CAUTION
fixed to the connectors so as to achieve the required seal.
NOTE
The use of an appropriate suction pipe from our product range is recommended.
 Trim the tube to the precise length
 Slide the union nut (Pos.
tube to the taper up to the stop collar (Pos.
 Insert the O-ring (Pos.
 Place the suction pipe (Pos. 9) in the delivery bundle.
6.2

Electrical installation

 Connect the mains power supply cable to the power grid.
417101339_EMP_II_E10
Pos. Description
1 Metering tube
2 Union nut
3 Clamping piece
4
Tapered part
5
Pressure-side O-ring (metering)
6 Pressure valve
7 Vent screw
8 Vent connection
9
Vent hose (not supplied)
10
Suction valve
11 Suction-side O-ring
12 Tapered part
13 Clamping piece
14 Union nut
15 Metering hose
P
Pressure side
S Suction side
Fig. 6.7
2 & 14) and clamping piece (Pos.
5 &11) into the valve groove and tighten the union nut.
3 &13) over the tube and attach the
4 &12).
40
& 11) are
5
Rev. 10-01.19