Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation example 6
Installation example 7
6.3.3
Connection of the suction and pressure lines (dosing lines)
CAUTION!
Ensure that the required seal is achieved when connecting the suction and
pressure lines by fitting O-rings on the connections.
The use of a suction pipe with an empty signal provision and dirt trap from our
accessory programme is highly recommended to protect the metering system.
The empty signal system causes the pump to cut off if the medium in the
container drops below a certain level.
Assembly, installation, modification and upgrades
The suction line must always be installed sloping upwards towards the
metering pump.
A metering monitoring instrument, such as an oval gear motor (pos. 1), or
flow monitor, must be installed into the metering line downstream of the
overflow valve and upstream of a pressure control valve or metering valve.
37
417102264 Rev. 5-01.2019
Publicité
Chapitres
Table des Matières
Dépannage
