Features - 'Ecopro - Ecolab EcoPro-ES-00510X-PFC-00S-1S-S0 Manuel D'utilisation

The pumps consist of three main assemblies:
n Housing with driver unit
n Pump head
n Control unit.
The construction has been chosen so that it is very easy to change between the 'EcoPro'
and 'EcoAdd' (
on page 71). The control units can also be rotated variably on the housing (
11.2.1 'Modification - turning the pump head' on page 69).
On the supplied mounting plate, the pump can be fastened without tools both for stand
mounting and wall mounting (
mounting to wall mounting' on page 70).
CAUTION!
The use of a suction pipe with an empty signal provision and dirt trap from our
accessory programme is highly recommended to protect the metering system.
The empty signal system causes the pump to cut off if the medium in the
container drops below a certain level.
4.1

Features - 'EcoPro'

n Buttons: On/Off, Test
Viscosity: high/low
n
n Setting range: 1:100
LEDs: Operation, viscosity high/low, alarm
n
n Connection board with connection points for:
– Power supply
– Enable signal
Ä Chapter 11.2.3 'Upgrading - From 'EcoPro' to 'EcoAdd' '
Ä Chapter 11.2.2 'Modification - change from stand
Functional description
25
Ä Chapter
417102264 Rev. 5-01.2019