6.3.1.2.2 Schlauchanschluss Mit Kegelteil Und Spannteil - Ecolab EcoPro Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Montage und Installation

6.3.1.2.2 Schlauchanschluss mit Kegelteil und Spannteil

1
2
3
4
5
6
Abb. 11: Rohr- Schlauchanschluss mit Kegelteil
1
Schlauch
2
Überwurfmutter
3
Spannteil
4
Kegelteil
1.
Schlauch (Pos. 1) gerade abschneiden.
2.
Überwurfmutter (Pos. 2) über Schlauch (Pos. 1) schieben.
3.
Spannteil (Pos. 3) über Schlauch (Pos. 1) schieben.
4.
Schlauch (Pos. 1) bis zum Anschlagbund auf Kegelteil (Pos. 4) schieben (Detail A1).
5.
Spannteil (Pos. 3) Richtung Kegelteil (Pos. 4) schieben bis Widerstand spürbar ist.
6.
O-Ring (Pos. 5) in Nut von Saug-, bzw. Druckventil (Pos. 6) legen.
7.
Überwurfmutter (Pos. 2) festziehen (Detail B1).
417102264 Rev. 6-12.2019
A1
B1
42
5
O-Ring
6
Saug-, Druckventil
A1 Rohr bzw. Schlauch aufgesteckt
B1 Ventilanschluss: Sollzustand nach Zusammenbau

Publicité

Table des Matières
loading

Table des Matières