Metering Enable - Ecolab EcoAdd Manuel D'utilisation

Control / Software
7.10.7

Metering enable

With the metering enable function activated, the pump only runs if an external enable
contact is closed at terminal 20 and terminal 21 (see
on page 56 and
on page 79). The selected operating mode does not affect the use of the metering enable
function. A missing enable function is indicated in the display with a symbol.
Fig. 53: Configuration: Metering enable
Factory setting: No metering enable
[Metering enable] - setting:
1. [Call up the Main menu] :
2. [Select Configuration] :
3. Use the scrollbar to scroll to the [menu item Metering enable] .
4. [Select Metering enable] .
ð Screen switches to the [selection Metering enable].
5. If required, select the selection field 'With metering enable.' .
ð A check mark is set in the selection field.
6. Press the
ð The setting is saved, and the screen switches back to the configuration overview.
7.
By pressing the
8.
By pressing the
Fig. 54: Metering enable on the operating screen
If the Metering enable function is activated, a white X with an orange
background appears in the top right-hand corner of the start screen to
indicate waiting for an enable pulse.
417102276 Rev. 5-02.2020
Ä Chapter 7.9.2 'Operating mode [Manual] (with 'metering enable' )'
3
5
4
Ä Chapter 7.7 'Main menu' on page 73
Ä Chapter 7.10 'Overview - Configuration' on page 92
button.
button, you can return to the [main menu].
button, you can return to the [operating display].
Ä Chapter 6.4 'Electrical installation'
6
102