Calibration Data Table; Operating Data; Overview - Ecolab Elados EDPL V60 Notice Technique

10.5.4.1 Calibration data table

The pump capacity in l/h is allocated to the pump's electronics on the basis of the calibration
values entered in the table.
Example:
NOTE
These values relate to the metering medium, i.e. water, at 20°C.
Fig. 10.56
10.6

Operating data

Open main menu as descripted at chapter
Acknowledge your choice with the Start/Stop key. If you push the  and  keys at once
(Function: „Menü Exit") you get back to operating mode.
The following operating data is recorded and displayed under this menu item:
•
Hours in operation, Litres, Number of pulses
The values in "Operating data" are updated anew every time the "Operating data" menu
NOTE
option is called up. This means that if the operating data is called up while the pump is
running, the incrementing of the values is not displayed.
10.6.1

Overview

417102214_EDPL_V60.docx
specified value of 3.67 l results in a pump capacity of 220 l/h.
Pump Pump capacity [l/h]
220
480
670
10.1 and go to
Fig. 10.57
see chapter
see chapter
see chapter
103
Pump calibration value [l]
3,67
8,0
11,17
by using the  key.
operating data
10.6.2
10.6.3
10.6.4
Rev. 1.12.11