Terminal Assignment On The V60 Plus Dongle Board; Installation Of The Oval Gear Meter - Ecolab Elados EDPL V60 Notice Technique

8 Upgrading the
Use the dongle board from our product range to upgrade the
and thus to access the additional functions. (Item no. 249629, EBS no. 10079744).
In order to mount the dongle board, open the housing of the pump, as described in
chapter 7.2.3
The automatic detection of the dongle board can only take place once the pump has been
NOTE
fully isolated from the voltage supply for at least 10 seconds (it is not enough to set the
on/off switch to "0").
8.1 Mounting the
Fig. 8.1
 Open terminals
 Push the dongle board (1) into terminals
 Re-tighten terminal screws
8.1.1 Terminal assignment on the
Terminal
25
26
27
28
29
30
8.1.2 Installation of the oval gear meter (OGM or OGM
The oval gear meter function must be enabled first of all in the menu. If an OGM
NOTE
connected, the oval gear meter function is automatically enabled
(see chapter
Fig. 8.3
417102214_EDPL_V60.docx
EDPL V60
"Overview of the control board".
PLUS
V60 dongle board
Pos. Description
X2 Terminal strip X2
1
Dongle board
2
Terminals 19, 20, 21, 22, 23, 24
 Mount the dongle board (1) on terminals
strip X2
19 to 24 before inserting the board.
19
V60
Wire
colour
Assignment
(Connection
cable)
Brown Output 5 V DC
White Bus cable
Black Pulse input
Blue GND
Free for future use
10.4.12 "Configuration / Oval gear meter
PLUS
to EDPL V60
(2).
19 to 24 which are now open (2).
to 24 in order to fix the dongle board in place.
PLUS
dongle board
PLUS
OGM
PLUS
25 + 26 + 27 + 28
Terminal Assignment
25 Output 5 V DC
26 Bus cable
27 Pulse switch input
28
GND ( ┴ )
80
EDPL V60 to EDPL V60
19 - 24 on terminal
Fig. 8.2
connection
( on the dongle board
PLUS
(V60 & OGM or OGM
PLUS
connection
OGM
PLUS
Plus
is
PLUS
only)").
Rev. 1.12.11